Customize - Tape Layout
This form allows
you to change the layout of your printed sight tapes. Most of the
options listed on this form should be self explanatory. The following
notes should clear up any questions you may have on the remaining
options.
Archer’s
Advantage supports 21 printer fonts. However, you may see only a few of
these fonts listed on the Tape Layout form. When the Tape Layout Form
loads, Archer’s Advantage checks your printer driver for supported
fonts. Only fonts supported by both your Printer and Archer’s
Advantage will show up on the Font List.
Archer’s
Advantage supports three font sizes. However, some Font Type/Font Size
combinations may not be supported your printer. If you select a Font
Type/Font Size combination that is not supported by your printer, the
range numbers will not print in the proper location or size on your
sight tapes. If the range numbers do not print properly on your sight
tapes, select a different Font Type or Font Size. Changes made at the
Tape Layout form will apply only to the Setup currently selected on your
Main Form.
The Max Range
selection allows you to limit the maximum range printed on your sight
tapes. Archer’s Advantage defaults to 150 Yards/Meters on
installation. The software will not always print to Maximum Range
specified on the Tape Layout Form. On slower bows, a 150 yard sight tape
would not fit on your sight. Archer’s Advantage automatically limits
the maximum range printed to marks that will fit on a 4" Sight
Tape. |
